REVO BLACK10

Durametal frame

The aluminum frame is designed to the limit while reducing the strength without reducing the strength.

Material setting considering tough use in salt.

Durametal side plate

The side plate is titanium coated on aluminum.

It becomes a full-metal configuration along with the mainframe,

Hooking without distortion and retrieval without blurring became possible.

When casting a lure with large air resistance in windy open water,

From the beginning of the throw, the lure is pushed back by the wind and tends to backlash.

So, from the moment the lure is released, the brake is sure

It is equipped with a MagtraxIII brake system that uses magnets that work well.

With a thickness of 1.5mm is factory magnet 2 is, the thickness of 3mm of the magnet been equipped with five, it has become a set of IMR favorite.

In addition, three 1.5mm magnets are included, so you can adjust the number to your liking.

Power stack carbon matrix drag

Normally, when there are two drag washers, only one side is effective,

By adding irregularities on the outside diameter of the drag washer, one more surface than usual

Demonstrate the effects of three sides.

It offers excellent drag performance as well as maximum drag.

D2 gear design large caliber brass gear

Equipped with a strong large-diameter brass gear, durability and strength have been improved,

Fighting with big game can be done with strong gear.

Dura clutch

The operating section has been thoroughly redesigned, resulting in a clutch structure that is easy to disengage and has improved durability.

φ33mm aluminum machine cut deep spool

16lb-100m line capacity. A long throw and an almighty setting at a short distance when aiming for a big fish.

Double finger knob

Two fingers can be hung, its shape and length transmit power firmly to the reel and wind up instantly,

Bring it to hooking and remove big fish from heavy cover without giving fish control

It is possible to drag.

Securely secured with a 4mm thick handle arm

High strength brass gear shaft & stainless steel handle knob shaft

Support shafts often made of aluminum for the purpose of weight reduction.

Not aiming for lightness, seeking the ultimate in rigidity,

High-strength brass on the drive gear shaft,

Stainless steel is used for the handle knob shaft.

Super free HPCR-BB

Minimizing ball bearings is a way to reduce drag, but it is more vulnerable to load.

Abu Garcia reviewed the design of the ball raceway of the bearing,

Successfully developed low ball bearings.

Improved low trajectory pitching and long-throw performance.

Salt Shield TM pinion bearing

By adopting a newly developed ball bearing with a water-repellent coating on the entire inside and outside,

Dramatically reduced salt-gami phenomena that cause abnormal noise.

The rotary feel and durability have been greatly improved.

It is adopted for the pinion gear section where salt crystals are most likely to remain on the double-axis reel.

Pinion gear support shaft

Extend the pinion gear support shaft and support the support point with ball bearings

The load on the shaft during winding and hooking

It has become possible to disperse the whole body.