REVO ELITE7 / 6 IB

Durametal frame

The aluminum frame focuses on weight reduction without sacrificing strength

Extreme design.

Material setting considering tough use in salt.

Infinibu rake system

A centrifugal brake that uses a spring mechanism for each block of the 6-point brake system,

“Infini brake system” that can be used with a high-performance magnet brake system.

It is safe even when you are worried about line troubles, such as headwinds. Centrifugal brake with one reel

A brake system that utilizes the advantages of each magnetic brake.

Power stack carbon matrix drag

Normally, when there are two drag washers, only one side is effective,

By adding irregularities on the outer diameter of the drag washer,

Demonstrate the effect of three sides, one more than usual.

It offers excellent drag performance as well as maximum drag.

 

D2 gear design large caliber super duralumin gear

The large-diameter gear balances stable winding speed and power.

And because it uses super duralumin, it is both lightweight and strong.

Dura clutch

Thoroughly review the operating section, easy to cut,

The clutch structure has improved durability.

Super light duralumin super lightweight φ33mm SLC spool

Infini spool design

The weight of the spool that determines the casting performance.

We designed a thin wall while securing a line capacity of 14lb-100m and a line capacity of 16lb-85m corresponding to big game,

While analyzing the strength, the spool that has been thoroughly reduced in weight,

A synergistic effect with the InfiniBrake resulted in a different-dimensional cast feel and casting performance.

Recessed reel foot

The split reel foot pushes down the spool, making it even more low-profile.

Height from the foot is about 40mm. Provides comfortable palming performance.

90mm crank carbon handle + big flat EVA knob

Lightweight, high power 90mm handle

Uses a large flat knob made of EVA material that is lightweight and easy to grip

Articulated side plate

The articulated side plate prevents loss due to falling when adjusting the brake.

C6 side plate

The original new material C6 carbon is an engineering plastic reinforced with carbon fiber,

Its stiffness is comparable to magnesium.

By adopting this material,

Significant weight reduction without sacrificing strength and durability.

Salt Shield TM pinion bearing

By adopting a newly developed ball bearing with a water-repellent coating on the entire inside and outside,

Dramatically reduced salt-gami phenomena that cause abnormal noise.

The rotary feel and durability have been greatly improved.

It is adopted for the pinion gear section where salt crystals are most likely to remain on the double-axis reel.